Millenium MCT-10 5pin cable tester and continuity tester

This little contraption will save your time when testing out various leads. All you need to do is plug the leads on both sides and start rotating the dial in order to test the cable one lead at a time.

Cable tester technical details:

• Operating voltage:
  • Powered by 9V battery, which is know with the following designations:
    • 6LR61 (Alkaline battery)
    • 6LP3146 (Alkaline battery)
    • Neda 1604A (Alkaline battery)
    • Neda 1604D (Zinc-carbon battery)
    • NEDA 1604LC (Lithium battery)
    • IEC 6F22 (Zinc-carbon battery)
    • MX1604 (Alkaline battery)
    • MN1604 (Alkaline battery)
    • CP9V
    • PP3
    • E-block
    • E
• Suitable connectors for tester (mostly for audio cables):
  • Male 5pin DIN 180°
  • Male 6,3mm TRS plug
  • Male RCA (phono, cinch )
  • Male 2pin and 4pin Speakon
  • Female<->Male 3pin XLR
  • 4mm banana leads
  • If you need to extend this tester functionality to any other special cables, then the best place is to stick your max 5pin adapters into the tester's 5pin female DIN connector.
• Construction:
  • Full metal construction
    • The only thing you can possibly break is the selector switch shaft.
• Functions:
  • Test wires one by one. LED's will indicate which pin on the right goes to which pin on the left.
  • By using banana connectors one may probe for continuity (buzzer beeps when those connectors are shorted). Do not probe from bananas to the connector pins, you'll end up breaking something... based on our own user experience.