ELT LC 125/350-A constant current control gear for LED modules

This control gear provides a constant current output, which is essential for the safe and efficient operation of LED modules, ensuring that the LEDs receive the correct amount of current, preventing overdriving and extending the lifespan of the LED modules. This control gear can potentially support LED modules with a total power consumption of up to 125 watts. It can be used in various lighting applications such as streetlights, floodlights, landscape lighting, displays, signage, and architectural lighting solutions.

Features:

• Indoor use.
• Equipped with terminal cover and cable clamps.
• Clamping screws on primary and secondary circuits for cables with diameter 3-8mm.
• Max. terminal section area 2,5mm². (secondary circuit).
• Max. length of secondary cables 5m.
• Suitable for installation on wooden surfaces.
• Standby ecological mode:
  • <0,4W
• High power factor.
• Thermal protection.
• Overload protection.
• Short circuit protection
• Protection against no load operation.
• LED module dynamic protection.
• Permitted input voltage AC/DC:
  • 198...264V.
• Nominal lifetime at max. ta allowed 50.000h (with a failure rate max.0,2% per 1000h).
• Output ripple current:
  • < 5%.
• Reference number:
  • 9918015
• Output power:
  • 25W
• Output current:
  • 350mA
• Frequency:
  • 0...50-60Hz
• Output voltage range at 240V:
  • 9...72VDC
• Output voltage range at 110V:
  • 15... 61VDC
• Power factor:
  • 0,90
• System efficiency:
  • >85
• Max. temperature at tc point:
  • 85℃
• Operating temperature:
  • -25...+55℃
• IP protection:
  • IP20
• Electrical protection:
  • Class II