7W 5,65kΩ 230V 30-35°C heat mat with power controller 150x280mm, Europlug CEE 7/16, 1.4m cable *new*

Convenient heating resistor for nifty intallations where heat is needed, for eg. inside an appliance chassis to heat up the internals to a plus side. Heating mat can be connected to continuous 230VAC electrical supply and the temperature will not rise significantly over 30°C (unless you will isolate it inside urethane or styrofoam). Alternatively this can be used with thermostat, which allows for temperature adjustment. Heating mat is as well suitable for warming lizards, turtles (or tortoises), reptiles or other terrarium (or vivarium) animals. Heat mat can't be submerged into water and naturally it is forbidden to install it reclessly for example with a staple gun by piercing the resistive element with staples... Same goes for screw installation and nailing.

Heating element technical details:

• Construction:
  • Film resistor laminated between transparent plastic films
• Resistance
  • 5,65kΩ
• Installation method:
  • Up to your imagination
• Electrical connection:
  • Europlug CEE 7/16, 1.4m cable
• Rated power:
  • 7W
• Operating voltage:
  • 230V
• Overall dimensions:
  • 150x280mm
• Typical surface temperature:
  • ~30...35°C depending on your installation environment and if the heat can conduct away well from the heat mat or is it insulated with some material.
  • Heating power can be throttled down by adjusting the controller's switched potentiometer (switched = potentiometer has a built in power switch as well).