3D printed device enclosure for decade resistor box (b-model), blue PLA *new*

A tiny bit messed up box for decade resistor box. Inside can house 7pcs ~42mm wide PCB's. 2x banana connectors and 7pcs 11-position selector switches can be mounted into front plate. What has been "messed up" was 11-position selector switch (and couple were missing), slightly too narrow for about 44-45mm PCB's, but this can be built into something else than what it was initially designed for.

Prints technical details:

• Material:
  • Blue PLA
• Outer dimensions:
  • 152x73x149,4mm
• Suitable card size:
  • ~42x1,7x135mm
• Mounting holes:
  • 3,6mm

Due to the wire deposit 3D printer nature the measurements might slightly vary between units. Ie especially small holes and details might vary slightly one way or another. Erro between print/measurement is typically somewhere around +/-0,3mm from nominal dimensions. Alternatively larger errors might be caused by different revisions, that might be on sale here, but if the outcome will different significantly it will be featured as another product.